Silanized polyurethane sealant BRIK-CEN PM-30 black box 12 cartridges 280ml Quiadsa

12 cartridges elastic sealant based polyurethane silanized. Free isocyanates, silicones, and solvents.

properties

• Application temperature 5⁰C to +40 ⁰C
• Temperature resistance -40⁰C to + 90 ⁰C
• High quality
• Resistance to aging
• Weatherability
• High resistance to UV radiation
• low odor
• no decline
• non-yellowing
• Interior Exterior
• elasticity permanent
• paintable

Applications

• Grouting under construction.
• Sealing air ducts and air conditioning or refrigeration.
• Sealing precast frame / work, metalwork.
• Ssuperimposed galvanized sheet, metals or nonferrous ferrous, caravans or trucks elements

Accession

Excellent adhesion:

Concrete, brick, wood, brickwork, natural or artificial stone ceramic, glass, metals such as aluminum, iron, zinc, galvanized, etc .., most thermoplastics (except polyethylene or PTFE) or thermosetting. Good adhesion on wet surfaces.

Chemical resistance

Resists water, aliphatic solvents, dilute acids and alkalis inorganic, oils and fats.

Poor resistance to aromatic solvents, to acids and chlorinated hydrocarbons concentrated

Cleaning

Clean with BRIK-CEN S 890 product, when the product is not hardened. Once hardened, cleaning is mechanically.

sealant performance

L = 280 / (axp)

L: length of the sealing m
to: Joint width mm
p: depth of the joint in mm

adhesive performance

Approximately 12 meters, shoelaces application of 5 mm in diameter.

How to use

The surfaces applied must be firm and completely clean. It can be applied on wet surfaces.

The sealant / adhesive can be painted, the most suitable time for painting is immediately after skinning of the same, approximately 40 minutes after being applied.

It can be used in proximity to paint booths.

Because of the wide variety of paintings on the market, we recommend testing the compat ibili ness of it with sealant / adhesive.

Sealing: Apply using a gun, pneumatic or manual, forming a continuous bead and avoiding forming air pockets. Then smooth with a wet spatula in soapy water

Joint dimension

The board must be designed according to the movement capability of the sealant. In general, the board must have a thickness between 5-25 mm.

The relationship between width and depth depend on the width of the joint.

In general, for together more than 10mm, the relationship between width and depth should be approximately 2: 1 respectively.

For smaller joints, the ratio should be about 1: 1.

Gluing: apply one of the joining surfaces forming strands according to the dimensions of the parts.